Place Maintenance HVAC, Plumbing Products Reduce Emergencies

Your water heater is one of the most used and more appliances in your home, and consumes a large involving your energy dollars each month. And experts say regular care and maintenance is essential to protecting your investment and saving at your home heating and costs.

Regular flushing of one’s water heater has become single most important step you can take to prolong its service life this particular save energy. During time, sediments amass in the bottom of your hot water heater. These sediments act as a barrier between the flame and the tank, thereby making your heater burn longer and hotter. This is not just destructive to the tank, but highly inefficient and will significantly raise your heating costs.

In most regarding the country, the normal water heater lasts 3-5 years. Regularly flushing your hot water heater can double daily life of your hot water heater from 3-5 to 7-10 years. Device costs of replacement running from $700 to over $1200 in some cases, getting the most out of your heater is vital in today’s economy. In addition, regular flushing makes your water heater run more efficiently and can cut heating costs fifty percent. Depending on the volume of hot water your home uses, that can mean a savings of $20 to over $50 a month or so.

To drain your water heater, you can find should set the thermostat to pilot (if it can be a gas water heater) or turn the circuit breaker off (if it is actually electric heater). Failure to do so could result in overheating and severe damage to the actual heater. Next, close the water supply valve located more than a water inlet line going into your water heater. After backing up connect a hose to the drain valve located at the base of the space heater. Open the drain and allow it working out until all of the water has emptied from the heating unit. Then close the drain. Open the water supply valve and refill the heater. You should also open a hot water faucet somewhere indoors and stand there and watch it run for several minutes until water flows out gradually. This will allow air to vent from the heater and the hot water lines. Finally, you can turn the thermostat to its regular setting (for a gas heater), or turn the circuit breakers back on (for an electric heater).

Besides regularly flushing your water heater, plumbing experts also advise adding a water treatment system to your residence to filter or condition the water so may less corrosive to your plumbing system, particularly in areas possess hard this type of water. For more ways to care for and protect your home plumbing system, contact a licensed, professional plumbing contractor in location to discuss options and products to work for you.

Abacus Plumbing, Air Conditioning & Electrical

The Woodlands, TX

(281) 528-1610

https://goo.gl/maps/Fccz1JjKrjN2